Routing

Open the Routing dialog to define the routes to be used by the camera for connecting to different networks. Connections via the Ethernet interface can be used as well as ISDN data connections.

In general, the camera can only send network data using a connection previously configured in the Ethernet Interface and ISDN Data Connections (Dial-In Connection or Dial-Out Connections tabs) dialogs.

Note:	Make sure that you create a route for every ISDN dial-out connection; otherwise the camera does not dial out.

Introduction

A network is defined by the network address and the network mask. For example, by factory default the camera is configured to an IP address within the network 10.0.0.0/255.0.0.0 (network address/network mask).

Networks are connected through gateways. This may be an ISDN router or a special computer within the network.

In order for each computer within the network to know if and how it can connect to computers in other networks, you need to configure routes. A route consists of the following information:

The target network data (network address and network mask).
The IP address of the gateway. This information is not needed for ISDN data connections since the service provider automatically acts as gateway in this case.
The connection to be used.

If a network package is to be sent to a specific target IP address, the camera checks if a route exists for this address. If no specific route exists, or no routes have been defined, the so-called Default Route is used.

The Default Route

Select the connection to be used by default. In general, this is the connection to your Internet Service Provider or to the closest gateway.

If you select the Ethernet Interface connection, you need to enter the IP address of the Gateway. Valid gateway IP addresses need to be accessible within the camera's local network (as defined in the Ethernet Interface dialog).

Note:	If you have activated the BOOTP/DHCP option in the Ethernet Interface dialog, the Default Route is always set to the Ethernet Interface with the Gateway IP Address being determined automatically.

If you select an ISDN Dial-Out Connection, the camera accepts the DNS server's IP address proposed by the service provider.

Network Routes

Enter the routes to other networks.

Enter a name for the route. Only use letters, digits, dot, hyphen and underscore.
Enter the target network information: Destination Network and Network Mask.
Enter the IP address of the Gateway. This IP address must be part of the local network of the camera. For routes using ISDN data connections, this field remains empty since the gateway is set automatically.
Select a Connection.

Note: If you have selected an ISDN connection, you cannot access computers within this network using the symbolic DNS name but only via their IP address.
For each connection, you can select one of of two options:

inactive Deactivates this route entry.

remove Removes this route from the configuration.
Click on the Set button to check the routes. Provided that the respective gateways are available, the configured routes are saved.

Note:	If you have selected an ISDN connection, you cannot access computers within this network using the symbolic DNS name but only via their IP address.

inactive	Deactivates this route entry.
remove	Removes this route from the configuration.

For additional information on the topic, see the Routing - Example help page.

Memorizzazione della configurazione

Fare clic sul pulsante Imposta per attivare le impostazioni e salvarle fino al successivo riavvio della videocamera.

Fare clic sul pulsante Chiudi per chiudere la finestra di dialogo. Durante la chiusura della finestra di dialogo il sistema verifica eventuali modifiche nella configurazione. Se le rileva chiede di memorizzare in modo permanente l'intera configurazione.

Per attivare queste impostazioni è necessario memorizzare la configurazione e riavviare la videocamera!

cn, de, en, es, fr, it, jp